Command Communications ComSwitch 8500-t Información técnica descargar pdf (Pagina 46)

G2T Programmers Guide Rev-A 17-Nov-2014

5.2.3. GET? and SET Values

Below is a table of the available properties that can be read and

changed. Note that each one behaves differently so consult the

table.

Code

Title

Access

Function

Outputs

Largest output

Inputs

Largest input

Modules

number of modules for which the system is configured

Last query error

last query error or zero (see note 1)

Slot that the module is in

set: (see Note 2) Get: returns the slot where the module

should be

Inputs on module

set: (see Note 2) Get: returns the number of inputs on the

module

7 Outputs on module RW set: (see Note 2) Get: returns the number of outputs on the

module

8 Slots RO number of slots in the system

9 Module in slot RW set: (see Note 2) Get: returns module number in slot or 0

10 Module ID in slot RW set: (see Note 2) Get: returns ID of module in slot or 0

11 [Project]

12 [Project]

13 [Project]

14 Dual State RO 1 is alone, 2 is primary, 3 is secondary

15 Fault FIFO RO Returns next fault or zero if empty, see note 3

Last Execution Error

last error or zero (see note 1)

[Project]

Ganged Modules

0 is un-ganged, 1 is ganged

Auto Interlock

auto interlock on (1) or off (0)

Auto Restore

auto restore on(1) off(0)

Debug mode

1: SPI traffic appears on Telnet port, 0: no traffic on port

24 Beep on Error RW beep on error (1) or silent (0) default is 1

25 Inactivity Timeout RW TCP/IP port inactivity timeout in seconds.

Values:

0 - disabled (i.e. port remains open until closed by host or the

FORceclose command)

1 - 28800 (8 hours) - number of seconds of inactivity until the

port is closed. Values outside the range are coerced to

28800. The default value is 0 (disabled).

Power Supply 1

Last status returned from PS1

Power Supply 2

Last status returned from PS2

Memories

number of "memories" available to *SAV or *RCL

Use 488.2

use backwards-compatibility mode (0)

System Integrity

if anything other than 21930, system restores factory defaults

on next reset

System cleared

1 if system restored defaults on last restart

Last Command Error

last error or zero (see note 1)

“This” CPU’s Current IP

address (MS)

nnn of nnn.XXX.XXX.XXX for current IP address

34 “This” CPU’s Current IP

address

RO nnn of XXX.nnn.XXX.XXX for current IP address

35 “This” CPU’s Current IP

address

RO nnn of XXX.XXX.nnn.XXX for current IP address

“This” CPU’s Current IP

address (LS)

nnn of XXX.XXX.XXX.nnn for current IP address

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 108 109

Comentarios a estos manuales

Sin comentarios

Command Communications ComSwitch 8500-t Información técnica Pagina 46

Comentarios a estos manuales

Relacionado con productos y manuales para Los conmutadores de red Command Communications ComSwitch 8500-t